X0-1 5682 Brushless Motor Mount
Click on Picture to Enlarge
As if 100mph is not fast enough! We know you RC addicts out there would be screaming for more. So install this kit and our Leopard 5682 1360KV motor running on 8S LiPo and watch what happens.
Mount accepts 56mm diameter motors. 4mm mounting screws, 30mm apart
Mount accepts additional RPM sensor
Includes extra thick 4.1mm aerospace grade aluminum top plate.
Click HERE for gear ratios and recommended gearing.
Includes Mount, top plate, hardware and installation manual
Add on motor, ESC, pinions and LiPos as needed
Caution! For high speed runs, use larger pinions only as the heat generated by motor and ESC allow. Motor temps should not exceed 160 degrees and ESC temps should not exceed 140 degrees.
X0-1 5682 Motor Mount Only
$79.99
|
Leopard 5682 1360KV Motor/
Castle Creations MM XL2 ESC
8mm Shaft
$346.99
|
Castle Creations
Cap Pack
A necessary addition to the 8S ESC to avoid damaging ripple voltages
$25.99
|
ESC Prep
Have your ESC show up w/
all wiring and plugs
soldered in place
$20
|
Pinion
Hardened
Steel Pinion
$24.99
|
2x Kershaw Designs
4S 5000mah
40C LiPo Packs
$145.99
|
|
|
|
|
|
|
|
